Aritech ATS3000 Betriebsanweisung PDF herunterladen (Seite 15)

ATS2000/3000/4000/4500 Manager’s Guide

DISARMING YOUR SYSTEM

When to disarm

If the area you want to enter is armed, you must first disarm the alarm system before you

can enter, otherwise you will set off the alarm. You will know which area is armed

because its LED on the keypad will be lit red.

The time limit when disarming

On entering the area, the system will allow you a preset time to disarm before an alarm

occurs

Disarming when there is an alarm

If there is an alarm condition when you are disarming the system, the alarm is reset. You

must then find out what caused the alarm and fix it. Use the function “Listing past alarm

events” to get a list of all the alarms that recently have happened (see page 21).

When you cannot disarm

You might not be authorised to disarm specific areas in the premises. See the earlier

section “When you cannot arm/disarm” on page 10 for more information.

To disarm the system

1. Before commencing, if there is no alarm in the area, the display must show:

2. Enter your PIN code.

3. Press [OFF].

4. The result of step 3 depends on:

• Whether the system has been programmed to display a list of the areas

assigned to your PIN.

Areas not displayed:

If your system has not been programmed to display a list of the areas assigned to

your PIN, all armed areas are now automatically disarmed (provided all zones were

normal). The display returns to that shown in step 1.

Areas displayed:

If a list of the areas assigned to your PIN is displayed, all armed areas are now

listed.

e.g.

There Are No Alarms In This Area

Code:

0-All 1, Office 2, Boardroom 3, Workshop

Enter Area:

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 70 71

Keine Kommentare

Aritech ATS3000 Betriebsanweisung Seite 15